Ford B-Max Forum banner
1 - 11 of 11 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter · #1 ·
Hi,
I've bought a second hand towbar which has some wires and connectors.

just wondering if those connectors are plug &play on the original loom or do i need the extra wiringkit?
(module not in pic. disconnected it)
TIA!

Hood Automotive tire Motor vehicle Bumper Fender
 

·
Registered
Joined
·
12 Posts
Discussion Starter · #4 ·
I knew I had seen some diagrams for this, but they took a while to find again.

thx! so all the cables shown in the picture are the ones that are needed?

when i look at the plugs on the towbar and on the car, 2 of them connects on the rear lights plugs, but there's one which i can't see where it goes.
 

·
Registered
Joined
·
12 Posts
Discussion Starter · #5 ·
So a little update on this...

Fitted the towbar within 1.5 hours and fits 100% mechanically.
The electrics however are a little different between model year.( came off 2014 and ours is 2017)
The module that came with the kit is a cv1j-19h378-aa and 2017 must be cv1j-19h378-ab.
and I'm missing 2 cable extensions.

Ordered the new wiringkit from Ford and everything should be sorted out.

I'll post the wiring diagram when delivered incase someone needs in the future.
 

·
Registered
Joined
·
12 Posts
Discussion Starter · #7 ·
Received the the new wiringkit and will post the short manual tomorrow.

Seems like the module in the wiringkit isn't the same before and after 2015...
before cv1j-19h378-aa and after cv1j-19h378-ab...

Can you enable the towbar via forscan with a Elm327?
 
1 - 11 of 11 Posts
Top