Ford B-Max Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hello!

I have Ford B-Max 2013, 1.5 L diesel engine, manual.
Recently i noticed that right front wheel bearing was going out, i decided to replace it with this - SKF VKBA 6653.
After replacing wheel bearing ABS + traction control + steering wheel lights all turned on after reaching around 15 km/h speed.
I thought that maybe right front wheel sensor was bad so I replaced it with this - BOSCH 0 265 009 270.
Still getting same lights on dash and no power steering, ABS.
I have Forscan with Vgate vLinker FS OBD2 USB adapter - checked all wheel speed and right front wheel sensor is showing spikes in graph - randomly losing signal (example - other wheels show 13 km/h and right wheel shows 8 km/h for a millisecond), i also switched right and left wheel sensors, so i believe sensors are fine.
When I used Forscan for first time i got Code: C0033 - Right Front Tone Wheel (also same codes that are in bottom of this post), so i thought maybe i put the wheel bearing incorrectly or damaged the magnetic ring, so i bought another SKF VKBA 6653 and replaced it again, made sure that ABS magnetic ring is facing sensor and that bearing is in correct position with circlip.
All this made no difference, still getting these DTCs, I tried to check cables that go to ABS module, they all seem fine, no apparent damage to cables.

Another problem that i cannot seem to solve is right rear passenger door that doesn't lock (window control also doesn't work), checked and the module that can be found inside door is getting 12V. I can lock this door manually with key, but it doesn't lock with remote control. Forscan shows this Code: B1087 - LIN Bus 'A'.
Cleared DTCs multiple times, only B1087 - LIN Bus 'A'. shows up when turning on ignition, other DTCs show up after reaching 15 km/h.

What could be the problem here? Non compatible wheel bearing? Faulty ABS module? Cables somewhere are damaged?
I cannot think of anything else, watched a lot of videos and blog posts about Ford fiesta, they all show simple solutions. I bought cable for Forscan just for this ABS problem and i still cant solve it, am I missing something?

Lights that turn on after 15 km/h:
Speedometer Odometer Vehicle Car Trip computer



Codes i get in forscan:
===PCM DTC U0415:00-64===
Code: U0415 - Invalid Data Received from Anti-Lock Brake System (ABS) Control Module 'A'

Status:
- DTC Maturing - Intermittent at Time of Request
- Malfunction Indicator Lamp is Off for this DTC
- Test not complete

Module: Powertrain Control Module

Freeze Frame #1:
-EVENT_TIME: 306983704 s (Fri Mar 07 16:38:28 2036) - Event time
-TOTAL_DISTANCE: 190490 km - Total Distance
-MODULE_VOLTAGE: 57.0 V - Control Module Voltage
-PWR_MODE_KEY: Running - Power Mode Key State
===END PCM DTC U0415:00-64===

===OBDII DTC U0415-P===
Code: U0415 - Invalid Data Received from Anti-Lock Brake System (ABS) Control Module 'A'

Status:
- Pending - malfunction is expected to be confirmed

Module: On Board Diagnostic II

===END OBDII DTC U0415-P===

===APIM DTC U0423:00-2A===
Code: U0423 - Invalid Data Received from Instrument Panel Cluster Control Module

Status:
- DTC Present at Time of Request
- Malfunction Indicator Lamp is Off for this DTC

Module: Accessory Protocol Interface Module

===END APIM DTC U0423:00-2A===

===FCDIM DTC None===
Successful DTC reading, no error codes found

Module: Front Control/Display Interface Module

===END FCDIM DTC None===

===ABS DTC U0401:00-68===
Code: U0401 - Invalid Data Received from ECM/PCM A

Status:
- Previously Set DTC - Not Present at Time of Request
- Malfunction Indicator Lamp is Off for this DTC
- Test not complete

Module: Antilock braking system

Freeze Frame #1:
-EVENT_TIME: 306983704 s (Fri Mar 07 16:38:27 2036) - Event time
-TOTAL_DISTANCE: 190490 km - Total Distance
-MODULE_VOLTAGE: 14.3 V - Control Module Voltage
-OUTDOOR_TEMPERATURE: 18 °C - Outside temperature
===END ABS DTC U0401:00-68===

===ABS DTC C0033:07-68===
Code: C0033 - Right Front Tone Wheel

Additional Fault Symptom:
- Mechanical Failures

Status:
- Previously Set DTC - Not Present at Time of Request
- Malfunction Indicator Lamp is Off for this DTC
- Test not complete

Module: Antilock braking system

Freeze Frame #1:
-EVENT_TIME: 306983703 s (Fri Mar 07 16:38:26 2036) - Event time
-TOTAL_DISTANCE: 190490 km - Total Distance
-MODULE_VOLTAGE: 14.0 V - Control Module Voltage
-OUTDOOR_TEMPERATURE: 18 °C - Outside temperature
===END ABS DTC C0033:07-68===

===RCM DTC U0401:00-08===
Code: U0401 - Invalid Data Received from ECM/PCM A

Status:
- Previously Set DTC - Not Present at Time of Request
- Malfunction Indicator Lamp is Off for this DTC

Module: Restraint Control Module

===END RCM DTC U0401:00-08===

===PSCM DTC U0401:00-48===
Code: U0401 - Invalid Data Received from ECM/PCM A

Status:
- Previously Set DTC - Not Present at Time of Request
- Malfunction Indicator Lamp is Off for this DTC
- Test not complete

Module: Power Steering Control Module

===END PSCM DTC U0401:00-48===

===PSCM DTC U0415:00-48===
Code: U0415 - Invalid Data Received from Anti-Lock Brake System (ABS) Control Module 'A'

Status:
- Previously Set DTC - Not Present at Time of Request
- Malfunction Indicator Lamp is Off for this DTC
- Test not complete

Module: Power Steering Control Module

===END PSCM DTC U0415:00-48===

===ACM DTC None===
Successful DTC reading, no error codes found

Module: Audio Control Module

===END ACM DTC None===

===IPC DTC U0401:68-28===
Code: U0401 - Invalid Data Received from ECM/PCM A

Additional Fault Symptom:
- Event Information

Status:
- Previously Set DTC - Not Present at Time of Request
- Malfunction Indicator Lamp is Off for this DTC

Module: Instrument Panel Control Module

===END IPC DTC U0401:68-28===

===GWM DTC None===
Successful DTC reading, no error codes found

Module: Gateway Module A

===END GWM DTC None===

===PDM DTC B1087:87-2F===
Code: B1087 - LIN Bus 'A'

Additional Fault Symptom:
- Missing Message

Status:
- DTC Present at Time of Request
- Malfunction Indicator Lamp is Off for this DTC

Module: Passengers Door Control Unit

Freeze Frame #1:
-EVENT_TIME: 306983471 s (Fri Mar 07 16:34:35 2036) - Event time
-TOTAL_DISTANCE: 190489 km - Total Distance
-MODULE_VOLTAGE: 12.8 V - Control Module Voltage
===END PDM DTC B1087:87-2F===

===DDM DTC None===
Successful DTC reading, no error codes found

Module: Drivers Door Module

===END DDM DTC None===

===HVAC DTC None===
Successful DTC reading, no error codes found

Module: Heating Ventilation Air Conditioning

===END HVAC DTC None===

===BCMii DTC U2005:81-08===
Code: U2005 - Vehicle Speed

Additional Fault Symptom:
- Invalid Serial Data Received

Status:
- Previously Set DTC - Not Present at Time of Request
- Malfunction Indicator Lamp is Off for this DTC

Module: Body Control Module

Freeze Frame #1:
-EVENT_TIME: 306983705 s (Sat Jul 31 09:51:59 2032) - Event time
-TOTAL_DISTANCE: 190490 km - Total Distance
-MODULE_VOLTAGE: 14.3 V - Control Module Voltage
-OUTDOOR_TEMPERATURE: 18 °C - Outside temperature
-PWR_MODE_QF: Power Mode Undefined - Power Mode Quality Factor
-PWR_MODE_KEY: Running - Power Mode Key State
===END BCMii DTC U2005:81-08===

===GPSM DTC None===
Successful DTC reading, no error codes found

Module: Global Positioning System Module

===END GPSM DTC None===
 
1 - 1 of 1 Posts
Top